Regal 2000 Uživatelský manuál stáhnout pdf (Strana 166)

KEEL OFFSET

By pressing the “ON/OFF MODE” keypad again, the alarm will

display the keel offset setting “KL”. It can be set so the depth ﬁ nder

shows the depth below the transducer, or the depth under the keel.

Press the up or down arrow keypads to adjust the reading to the

desired depth no further than 19.9 feet.

An example would be if the keel bottom is 3 feet below the transducer,

and you desire the depth sounder to read the depth below the keel, the

keel offset display should be adjusted to 3.0 FT.

Once the keel offset is programmed, the shallow and deep water

alarms will be energized by the depth under the keel.

UNITS

Pressing the “ON/OFF MODE” keypad again displays the units

mode “UN”. Press either the up or down arrow keypads to set the

units to feet (FT), meters (M), or fathoms (F). Once these units are

set, they will remain the same for all modes. By pressing the “ON/

OFF MODE” keypad again, the depth ﬁ nder will return to the normal

operations screen.

NOTICE

AVOID EQUIPMENT DAMAGE! THE TRANSDUCER IS A

SEALED UNIT. DO NOT ATTEMPT TO OPEN IT, SINCE IT IS NOT

SERVICEABLE.

6-18

Chapter 6

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 281 282

Žádné komentáře

Regal 2000 Uživatelský manuál Strana 166