Regal 2000 Uživatelský manuál stáhnout pdf (Strana 153)

BILGE PUMP

Before each outing, check the operation of the bilge pump, automatic

switch, and manual switch. The bilge pump should automatically

activate when water reaches a pre-determined height in the engine

compartment. Test the bilge pup manually at the dashboard with the

switch. Periodically check for bilge debris around the grates of both

the bilge pump and automatic switch, and also bilge pump impeller.

The automatic mode for your bilge pump works similarly to the

manual method. Both methods control the bilge pump by a switch,

but the automatic mode utilizes a ﬂ oat switch. Float switches have

a ﬂ oat that sits at water level, and when the ﬂ oat reaches a certain

height, it trips the switch and activates the bilge pump.

You may need to disassemble the bilge pump from the grate in order

to clean or access the inner mechanisms. To remove the bilge pump,

utilize the quick disconnect tabs on either side of the bilge pump,

squeezing them like a backpack clip while pulling up on the pump.

For switch control location, refer to the engine and controls chapter.

For bilge and drainage system information and electrical system

information, refer to the systems chapter. Refer to the vessel

operations chapter for pre0departure use. Maintenance requirements

are described in the maintenance chapter of this manual.

Typical Bilge Pump And Automatic Switch Diagram

6-5

Equipment Operation

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 281 282

Žádné komentáře

Regal 2000 Uživatelský manuál Strana 153